Parallel Telephone RingingSpecifies whether the sub telephone (SLT) rings at the same time as the main telephone (DPT) for an incomingcall. This setting is only available when Port Type on this screen is set to S-Hybrid.Value RangeYes, NoMaintenance Console Location3.5 [1-1] Slot—Port Property - Extension PortProgramming Manual ReferencesNoneFeature Guide References1.11.9 Parallelled TelephoneDPT Type—TypeSelects the port type.To change the port type of an extension port, follow the steps below:1. Set the status of the extension port to "OUS".2. Change the port type of the extension port, then click Apply.3. Set the status of the extension port to "INS".When changing the port type of an extension port for which Wireless XDP has been set on the6.1 [4-1-1] Wired Extension—Extension Settings screen, the Wireless XDP setting must be deletedfirst.When changing the type of a port for which one or more SDN buttons are set (except when changingbetween PC Console and Telephone), all SDN buttons customised for that device will be deleted. Whenyou attempt to apply the new settings, a warning message is displayed showing the slot and port numberfor which SDN buttons will be deleted. If you do not wish to delete SDN buttons for this port, clickCancel.Value RangeNormal: For connecting a DPTDSS: For connecting a DSS Console (A maximum of 4 [with the KX-TDA30], 8 [with the KX-TDA100/KX-TDA200] or 64 [with the KX-TDA600] DSS Consoles can be connected to the PBX.)VM (DPT): For connecting a Panasonic VPS through DPT IntegrationPC Console: For connecting a PC Console (A maximum of 2 [with the KX-TDA30] or 8 [with the KX-TDA100/KX-TDA200/KX-TDA600] PC Consoles can be connected to the PBX.)Maintenance Console Location3.5 [1-1] Slot—Port Property - Extension PortProgramming Manual References3.6 [1-1] Slot—Port Property - Extension Port—Connection Command122 PC Programming Manual3.5 [1-1] Slot—Port Property - Extension Port
