2.6 Utility2.6.1 Utility—DiagnosisPerforms diagnostic tests on cards installed in the PBX, to identify the source of problems.If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results can besaved as a TXT-format (text) file.When testing is complete, any cards that were set to OUS status must be returned to INS status if they are tobe used again.Card TestTests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary accordingto the type of card being tested.The tests that are performed on each card are as follows:KX-TDA30Test Type Available CardsLocal loop back diagnosis DHLC4, DLC8, SLC4, SLC8, IP-EXT4, LCOT, DID3, BRI, IP-GW4,SIP-GW4, E1Card CT Bus diagnosis DLC8, SLC8, IP-EXT4, IP-GW4, SIP-GW4, E1DTMF Receive test port DHLC4, SLC4, SLC8MSG/SVM Card DTMF receive test MSG2, SVM2, ESVM2EXT-CID path test EXT-CIDDSP DTMF generator/receiverdiagnosisE1DSP DTMF receiver diagnosis E1Framer IC alarm signal detectiondiagnosisE1Framer IC error detection diagnosis E1KX-TDA100/KX-TDA200/KX-TDA600Test Type Available CardsLocal loop back diagnosis DHLC, DLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,ECSLC24, CSIF, LCOT, ELCOT, T1, E1, BRI, PRI, OPB, E&M, DID,IP-EXT16Card CT Bus diagnosis (KX-TDA100/KX-TDA200 only)DHLC, DLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,CSIF, LCOT, ELCOT, T1, E1, BRI, PRI, OPB, E&M, DID, IP-EXT16DTMF Receive test port DHLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,ECSLC24, E&M, DIDPT loop back diagnosis DHLC, DLCPC Programming Manual 612.6.1 Utility—Diagnosis
