1.10 Conversation FeaturesFeature Guide 1231.10.6 Flash/Recall/TerminateDescriptionThe FLASH/RECALL button (Flash/Recall mode or Terminate mode) or Terminate button(Terminate mode) is used when a PT user disconnects the current call and originates anothercall without hanging up first. It performs as going on-hook and then going off-hook.[Explanation of Each Mode]Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from theline used last. For example, if a trunk call is disconnected, the extension user will hear a newdial tone from the telephone company.Terminate Mode: Disconnects the line and the extension user hears the dial tone determinedby the Line Preference—Outgoing setting. ( 1.5.5.2 Line Preference—Outgoing)Conditions• FLASH/RECALL Button ModeOne of the following modes can be selected for each extension through systemprogramming:• Terminate ButtonA flexible button can be customised as the Terminate button.• Disconnect Time (Only for Flash/Recall Mode)The amount of time between successive accesses to the same trunk is programmable foreach trunk port ( LCOT Disconnect Time [418]).• This feature outputs an SMDR call record ( 1.25.1 Station Message Detail Recording(SMDR)), restarts the call timer, inserts the automatic pause, and checks the TRS/Barringlevel ( 1.8.1 Toll Restriction (TRS)/Call Barring (Barring)) again.• If the ARS mode is on ( 1.9.1 Automatic Route Selection (ARS)) or if a trunk call isestablished through the INTERCOM button or ICD Group button, the Terminate mode willbe always effective even though the Flash/Recall mode has been set.Feature Guide References1.19.2 Flexible Buttons– Flash/Recall mode– Terminate mode– External Feature Access (EFA) mode. ( 1.10.7 External Feature Access (EFA))
