1.1 General Features86 Feature Manual1.1.60 Flash/RecallDescriptionA proprietary telephone (PT) user can use the FLASH/RECALL button to disconnect the current call andstart another call without hanging up. For example, if this button is used to disconnect an outside (CO) line,the extension user will hear a new dial tone from the same outside (CO) line.Conditions• FLASH/RECALL Button ModeOne of the following modes can be selected through system programming ( [110] Flash/Recall KeyMode):a) MODE 1: EFA mode ( 1.1.56 External Feature Access (EFA))An EFA signal is sent for the specified duration ( [418] Flash/Recall Time).b) MODE 2: Flash/Recall modeA flash/recall signal is sent when the FLASH/RECALL button is pressed if the length of time thatthe button is pressed is longer than the specified duration ( [418] Flash/Recall Time). If thelength of time that the button is pressed is shorter than the specified duration, an EFA signal willbe sent for the specified duration.• This feature functions only if the FLASH/RECALL button is set to "MODE 2: Flash/Recall mode".• Disconnect TimeThe amount of time between successive accesses to the same outside (CO) line is programmable foreach outside (CO) line ( [422] Disconnect Time).• Pressing the FLASH/RECALL button restarts the conversation duration, outputs an SMDR call record( 1.1.112 Station Message Detail Recording (SMDR)) and checks the Toll Restriction (TRS) class ofservice (COS) number again. The notation "F/" will be logged along with the new dial number on SMDR.Programming Manual References[PT Programming][110] Flash/Recall Key Mode[418] Flash/Recall Time[422] Disconnect Time[PC Programming]9.1.11 Detail [1-10]—Proprietary Telephone—Flash/Recall Key Mode9.3.3 Detail [3-3]—Flash/Recall Time, Disconnect TimeFeature Manual References1.1.56 External Feature Access (EFA)1.1.112 Station Message Detail Recording (SMDR)Operating Manual References1.3.46 Flash/Recall
