ParameterTransmitted CommandIn AA Service Mode In VM Service ModeAnswer by Mailbox Switching to VM command +Recording message command(#6 + H [H = Mailbox No.])Recording message command(H [H = Mailbox No.])AA Switching to AA command (#8) Switching to AA command (#8)None (Default) (DTMF commands are not sent. Work with default of the VPS.)[Example of a) & b)]Trunk CallOperator Extn. 102 VM Port 1 VM Port 2VM Port X VM Port 3VM (DTMF)GroupVPS (In AA service mode)FWD, InterceptPBXTransferSent "#6" + "102".Switching to VM commandmailbox numberc. Transferring to a Mailbox of the VPSAn extension user can transfer a call to a mailbox of the VPS so that the caller can leave a messagein the mailbox of the desired extension. (® 1.12.1 Call Transfer) The extension user should use theVoice Mail (VM) Transfer button, when transferring a call to the mailbox of the VPS.When the extension user presses this button and enters the desired extension number, the PBX willtransfer the call to the VM group and dial the mailbox number of the desired extension with the requiredcommand (after the VPS answers the call). Therefore the caller can leave a message without knowingthe mailbox number.6.5 [4-1-4] Wired Extension—Flexible Button® Type® Extension Number (for Voice Mail Transfer)6.13 [4-2-3] Portable Station—Flexible Button® Type® Extension Number (for Voice Mail Transfer)6.17 [4-3] DSS Console® Type® Extension Number (for Voice Mail Transfer)268 Feature Guide1.24.2 Voice Mail DTMF Integration
