Panasonic DIGA DMR-BW750 Operating Instructions Manual

Contents

99RQT9428ReferenceAdditional connectionsConnecting a television with S VIDEOterminalsThe S VIDEO OUT terminal achieves a more vivid picture than theVIDEO OUT terminal. (Actual results depend on the television.)y Connect to terminals of the same colour.y Supplied Audio/Video cable can also be used as an alternative forAudio cable without connecting the video connector (yellow).This unit’s rear panelS VideocableAudio/Videocable(included)Television’s rear panelOUTOUTNPR P B YONENTO OUTDIGITALAUDIO OUT(PCM/BITSTREAM)S VIDEOINAUDIO INR L VIDEOINConnecting a television withCOMPONENT VIDEO terminalsOPTICALCOAXIALOUTOUTAV1 INAV1 INS VIDEOVIDEOR-AUDIO-LPR PB Y10BASE-T/100BASE-TXCOMPONENTVIDEO OUTDIGITALAUDIO OUT(PCM/BITSTREAM)R- LAUDIO INR L PR P B YCOMPONENTVIDEO INTelevision’s rear panelThis unit’s rearpanelComponentvideo cableAudio/Videocable(included)COMPONENT VIDEO terminals can be used for either interlace orprogressive output (➡119) and provide a purer picture than the SVIDEO OUT terminal.y Connect to terminals of the same colour.y Supplied Audio/Video cable can also be used as an alternative forAudio cable without connecting the video connector (yellow).Required setting“Component Resolution” setting in the Setup menu (➡ 93)If you have a regular television (CRT: cathode ray tube)Progressive output may cause some fl ickering, even if it isprogressive compatible. Set “Component Resolution” in the Setupmenu to “576i/480i” (➡ 93) and “HDMI Video Mode” to “Off”(➡ 92) if you are concerned about it. This is the same for multisystem televisions using PAL mode.Progressive outputDO NOTCRTCOMPONENTVIDEO OUTThis unit COMPONENTVIDEO INConnecting a stereo amplifiery Connect to terminals of the same colour.y Supplied Audio/Video cable can also be used as an alternative forAudio cable without connecting the video connector (yellow).AUDIO INR LOUTOUTAV1 INAV1 INS VIDEOVIDEOR-AUDIO-LPR PB YCOMPONENTVIDEO OUTDIGITALAUDIO OUT(PCM/BITSTREAM)Amplifi er’s rear panelAudio cableThis unit’s rear panelConnecting an amplifier with a digitalinput terminalRequired setting“Digital Audio Output” in the Setup menu (➡ 90)y When this unit is connected to an amplifier with an optical digitalaudio cable or coaxial cable and connected to a television with anHDMI cable, you can enjoy the highest quality of audio from thedisc by setting “HDMI Audio Output” to “Off” in the Setup menu(➡92). In this case audio is only output from the amplifier not thetelevision.y Before purchasing an optical digital audio cable (not included),check the terminal shape of the connected equipment.■ With OPTICALy You cannot use DTS Digital Surround decoders not suited to DVD.OPTICAL INOPTICALCOAXIALS VIDEOVIDEOP B Y DIGITALAUDIO OUT(PCM/BITSTREAM)Insert fully withthis side up.Amplifier’s rear panelOptical digital audio cableDo not bend sharply whenconnecting.This unit’s rear panel■ With COAXIALOPTICALCOAXIALS VIDEOVIDEOO-LPB Y DIGITALAUDIO OUT(PCM/BITSTREAM)COAXIAL INAmplifier’s rear panelThis unit’s rear panelCoaxial cableÚ Leave “Yellow” unconnected.Convenientfunctions