98RQT9428Software of this unit can be updated automatically by followingmethod.y From broadcastsy From Internet [network connection and setting is required. (➡ 96,102)]Update of the software is done when it is in standby mode.Once the new software is found, it will start the download of thesoftware, and then update.Download of the software will start automatically when the power ofthis unit is turned off or when it is 3 a.m.y The time it takes to update depends on the connection.– For Broadcast: About 2 to 4 hours– For Internet: About 1 hour(It may take longer than specified above to download becausethe download time differs depending on the networkenvironment. It is recommended to be used in a broadbandenvironment.)If you do not want to perform the software update during thestandby mode, set “Software Update in Standby” in the Setup menuto “Off”. (➡ 94)■ If a software update is available, a notifi cation isdisplayed.For broadcast1 TEN HD All DVB Channels10:30Select FavouritesCorontation street9:00 - 11:00 NowRating:PGSoftware updateSoftware updatey Following screen is displayed when “Red” button is pressed.For Internety Update of the software will start when the power is turned off.■ The unit’s display during the updatey “SW-DL” : Software is downloading. Download will stopwhen the power is turned on, or the timerrecording starts.y “START”Ú : Update of the software will start once thedownload is completed.y “UPD
/
”Ú : Software is updating.y “FINISH” : Updated of the software has completed.Ú You cannot operate the unit until the update is complete.Removing the AC mains lead while the update is in progressmay damage the unit.Notey If the timer recording is scheduled within the following time at thestart of the download, the download will not be executed.– For broadcast: Within 4 hours– For Internet: Within 1 houry If downloading on this unit fails or this unit is not connected to theInternet, then you can download the latest software from thefollowing website and burn it to a CD-R to update the software.http://panasonic.net/support/Software Update
