83. Setup3-1. Setting the input signals3-1-1. Setting the input signals (IN 1 to 5)If HD has been selected as the system format, SDI or analog HD component can be selected for each input.This selection is possible only when the HD analog board has been connected.1 Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUPmenu.2 Turn [F1] to display the IN1 to 5 menu.3 Turn [F], select the input signals using the SIG item, turn [F3], and select SDI or ANLG (analog HDcomponent) using the MODE item.4 If analog HD component has been selected, turn [F4], and set the gain of the input signals using the GAINitem. The gain can be set within the 30-step range, and the setting will result in changes of dB.The amount by which the gain changes per step is not the same for each step.ANLGIN2IN3IN4IN5IN1-51/15 SIGIN1 MODESDI GAIN--30—303-1-2. Setting the input signal frame synchronizerThe frame synchronizer can be set to ON or OFF for each input.The input 6 (DVI input) frame synchronizer is permanently ON. It cannot be set from ON to OFF or vice versa.1 Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUPmenu.2 Turn [F1] to display the FS menu.3 Turn [F], select the input signals using the SIG item, turn [F3], and select ON or OFF for the framesynchronizer using the FS item.0''*/*/*/*/'4 4*(*/ '40/AVDL function is active while the frame synchronizer function is set to OFF.The AVDL function automatically adjusts the input image signal phase to the horizontal synchronizationreference signal phase.For details, refer to “3-6. Adjusting the output signal phase”.