Panasonic AJ-HPM100P Operating Instructions Manual

Also see for AJ-HPM100E: Mechanical Parts List Brochure & specs Operating instructions

Contents

Panasonic AJ-HPM100P Operating Instructions Manual Manual pdf 88 page image

88 Using Play List: Simplified Voice-OverSimplified Voice-OverThis function allows you to make voice-overs and give priority to the voice-over during playback. Recording is performed on oneor two channels. The channel input during recording can be mixed with the playback sound.◆ NOTE:• The voice-over data is written to the same card storing the play list.Thus the play list must be saved before audio recording or an errorwill be generated and recording cannot be performed.• The maximum recording time is 720 minutes.• The maximum number of voice-overs is 99.• Check the remaining time on the P2 card before saving the play list.Otherwise there may not be enough time for the voice-overrecording. When the P2 becomes FULL, an error occurs andrecording cannot be started.Make the required settings in the related setup menu prior toaudio recording.➝For details on settings, refer to “Setup” (page 106).Select the voice-over track from one of the following tracks insetup menu No. 792 (A DUB CH):CH1, CH2, CH3, CH4, CH1+2, CH3+4◆ NOTE:• Recording tracks can be selected when the play list does notcontain any voice-overs. When it does contain a voice-over,subsequent voice-overs use the same recording track.You can select whether to mix the playback sound during avoice-over in setup menu No. 793 (A DUB PB MIX).When mixing is selected, select the channels to mix in setupsubscreen.The playback sound of the selected channels is mixed with ADUB CH and recorded.When there are multiple A DUB CH, make separate settingsfor each.◆ NOTE:• In play list playback, playback level is set to UNITY fixed, orregistered recording level and cannot be changed. However, EEaudio while the A.DUB button is pressed and during A.DUB can beadjusted.• The playback level of short playback of voice-overs from still statuscannot be changed.In setup menu No. 796 (A DUB FADE), select whether thevoice-over should be blended with the original audio using cutor V-fade.➝Refer to “Playing Back the Play List” (page 94).➝Refer to “Creating New Clips From the Play List (Edit Copy)”(page 95).◆ NOTE:• When an audio is overwritten and added using cut to an audioadded by V-fade, V-fade will be applied to the connecting point.In setup menu No. 797 (A DUB MONI), select whether theaudio being recorded should be output during the voice-over.Connect a microphone to analog CH2 and mix themicrophone input with CH2 playback audio and use cutprocessing to record on CH2. Use headphones to listen to theplayback audio during recording.◆ NOTE:• Input a reference signal when mixing SDI input audio.• IEEE1394 input audio cannot be used for voice-overs.Preparing for Voice-OverSelecting a Track for RecordingMixing Playback SoundSelecting Method for Connecting Audio INand OUT PointsSetting Output Voice During A DUBSetup ExampleSelecting recording tracks A DUB CH = CH2Selecting mixing with playbacksoundA DUB PB MIX = ONCH2 MIX = CH2Selecting audio connection A DUB FADE = CUTDuring simultaneous A DUBsettingA DUB MONI = OFF