Setup: Changing Settings 107SetupChanging SettingsThe menus on the LCD monitor or a monitor (when the SUPER switch on the right side of the LCD monitor is set to “ON”)connected to the ANALOG COMPOSITE MONITOR OUT connector make it possible to change settings.1 Press the MENU button.The setup menu screen appears on the LCD monitor andthe counter display indicates the setup menu number.2 Select the file to change.• Hold down the SHIFT button and press the FF buttonor the REW button to switch to the next or previousfile.3 Select items to change.Turn the search dial or press the up (▲) or down (▼)buttons to move the cursor (*) to the item you want tochange.• Use the search dial in JOG mode.• Turn the dial clockwise to increment item numbers(001➝002➝003➝004➝) and counterclockwise todecrement them.• To switch to the next item, hold down the PLAYbutton and press the FF button or the + button. Toswitch to a previous item, hold down the PLAY buttonand press the REW button or the – button.4 Change set values.Select the item to change, hold down the STILL/PAUSEbutton and turn the search dial or press the left (b) orright (a) button to change the setting.• Turn the dial clockwise (or press the right (a) button) toincrement the set number and turn it counterclockwise(or press the left (b) button) to decrement it.• Release the STILL/PAUSE button after making thechange.• In the SHTL mode, set the search dial to the centerposition or items will move.• Repeat the operations described in steps 3 and 4 whenthere are more items to change.5 Finalize the change.Press the MENU button.In the confirmation message that appears, press the SETbutton to accept the change or press the EXIT button tocancel it. The menu closes after this operation.You can assign three of the items that are most often changedto the PF buttons to enable quick changes of the settingvalues.Change Operations1,54,552 3,43,4Making changes using the PF buttons21,3
