46 Clip Management: Copying ClipsCopying ClipsClips can be copied to a P2 card in any slot.◆ NOTE:• Take care not to turn off the power or remove a card during copying.Otherwise the copied clip may become bad.If the copied clip is bad, delete it and make a new copy.• Reconnect incomplete clips before copying them.1 Open the thumbnail screen.2 Select a clip to copy.3 Press the MENU button.4 Use the cross cursor buttons to choose[OPERATION] – [COPY] – [SLOTn] (the number ofthe P2 card slot where the copy will be placed) andpress the SET button.When multiple clips are selected, the number of selectedclips appear after pressing the SET button.5 Select [YES] and press the SET button.This starts copying.◆ NOTE:• To interrupt copying, press the SHIFT and EXIT buttons or theSET button to cancel the job.The incomplete copy at the destination is deleted.• [OVER WRITE] appears when an attempt is made to place acopy (having the same GLOBAL CLIP ID) at a destinationalready containing an identical item. Select [YES] to overwrite or[NO] to cancel copying and then press the SET button.6 Press the SET button when the completion messageappears.7 Press the MENU button to end processing.◆ NOTE:• No copying is performed when any of the following errormessages appear.• [LACK OF REC CAPACITY]Copy failed because there is not enough space at the copydestination.• [UNKNOWN CONTENTS FORMAT!]Copy failed because the selected clip was bad.• [NO COPY TO SAME CARD!]Copy failed because an attempt was made to place the copyon the same disk.• [TOO MANY CLIPS!]Copy failed because too many clips were selected.• Copying performed at the bottom row of a text memo when thetext memo is selected copies the selected text memo and thenext text memo. When there is no text memo beyond theselected text memo, all data to the end of the clip is copied.
