Using Play List: Editing Play Lists 75Using Play ListYou can change the IN and OUT points for a play list eventduring video playback.1 Open the play list screen.2 Select the event you want to change.3 Press the EVENT button.This activates the event edit mode.4 Register a new IN point.Use the operation buttons or search dial to look for alocation to start an event. Then hold down the IN buttonand press the ENTRY button.5 Register a new OUT point.Use the operation buttons or search dial to look for alocation to end an event. Then hold down the OUT buttonand press the ENTRY button.6 Press the EVENT button to end the change operation.◆ NOTE:• Steps 4 and 5 can be handled as alternatives, you do not haveto carry out both steps.• If the new IN point comes after an already registered OUT point,the existing OUT point will be reset. A return to the play listscreen will show that the OUT point has automatically beenchanged to the end of the clip.• If the new OUT point comes before an already registered INpoint, a return to the play list will show that the IN point of thatclip has automatically been changed and registered at thebeginning of the clip.• An event with a voice-over cannot be modified. Delete the voice-over before modifying the event.• The changed content will be neglected if the unit is turned offduring change of an event from video.You can change IN and OUT points for events in frameincrements (in 4-frame increments at 24PN).1 Open the play list screen.2 Select the event you want to change.3 Use the cursor buttons to change the IN point.Hold down the IN button and press the TRIM+ button orthe TRIM– button. The IN point is incremented ordecremented in frame increments (in 4-frame incrementsat 24PN).Press the ENTRY button to finalize.4 Change the OUT point.Hold down the OUT button and press the TRIM+ button orthe TRIM– button. The OUT point is incremented ordecremented in frame increments (in 4-frame incrementsat 24PN).Press the ENTRY button to finalize.5 Change the SPLIT pointHold down the SPLIT button and press the TRIM+ or theTRIM– button. The split point is incremented ordecremented in frame increments (in 4-frame incrementsat 24PN).Press the ENTRY button to finalize.Changing Event IN and OUT Points4,554213,6Trimming Events43 3,4,5 521
