Setup: Item Settings 119SetupDefinition of terms:This menu is used for video settings.* An underlined setting indicates an initial value.515 HD EMBD LTC00000001OFFONSpecifies whether or not LTC data will be superimposed on HD SDI output.0: Not superimposed1: Superimposed518 VITC GEN00000001OFFONSpecifies whether or not the internal time code generator value should be recorded in theVAUX area.0: The internal time code generator value is not recorded.Record the time code value when it is superimposed on input video signals.1: The internal time code generator value is recorded.NOTE:When 1394 is selected as the input signal, the time code signal superimposed on thecompressed input signal is recorded regardless of settings in this menu.519 UB OUT SEL00000001SBCF_RATESelects user bits in the LTC data output by the TIME CODE OUT and HD SDI connectorsor user bits in the SBC area (DVCPRO HD only) output via the IEEE 1394 terminal duringplayback of clips in 720/24PN, 720/30PN and 720/25PN formats as well as optional AVC-Intra 1080/24PN, 30PN and 25PN clip formats.0: Outputs the user bits recorded in the SBC area.1: Outputs the frame rate information recorded in the VAVX area.SBC (Sub Code Data) area: This area, which is separate from video and audio data area on a P2 card, stores SMPTE/EBU compliant time code, recording dates and other information.VAUX (Video Auxiliary Data) area: An area in the video data area on a P2 card that stores additional information on videodata.VIDEOItem SettingSettings and brief function descriptionFRNo.SUPERDISP.FRNo.SUPERDISP.601 VIDEO INT SG00000001000200030004100%CB75%CBSMPTEARIBBLACKSets the internal signal type. SMPTE and ARIB signals are available in HD mode only (blackin SD mode).0: 100% color bar1: 75% color bar2: SMPTE color bar3: ARIB color bar4: Black602 SDI IN MODE00000001DR OFFDR ONSpecifies the method for processing HD SDI input. (Available only for DVCPRO HD)0: Records the 8 higher bits after rounding up the two lowest bits.1: Records the signal with 8 higher bits, obtained by dynamic rounding.NOTE:Records 8 high-order bit signals after rounding off the 2 low-order bits during SD SDIinput.620 DOWNCONMODE000000010002CROPLT-BOXSQUEEZSpecifies the picture angle during down-conversion.0: Side cut mode1: Letter box mode2: Squeeze mode621 UPCONV MODE000000010002S-PANLCROPSTRECHSpecifies the picture angle during up-conversion.0: Side panel mode1: Top and bottom cut in vertical direction2: Stretch modeItem SettingSettings and brief function descriptionFRNo.SUPERDISP.FRNo.SUPERDISP.
