3 3.5 Turning the Machine On/Off and the Initial Mode3-14Before Making Copies or Faxing Chapter 33.5 Turning the Machine On/Off and the Initial ModeTurning the Machine On/OffTo turn on the machine: Press the | (on) side of the PowerSwitch.To turn off the machine: Press the 2 (off) side of the PowerSwitch.NoteDo not turn off the machine while a print cycle is being performed, as a papermisfeed will result. Before attempting to turn off the machine, always be surethat the current print cycle has been completed.Turning off the machine will initialize all settings except those for previouslyprogrammed jobs and for the Utility mode.Do not turn off the machine while it is scanning or sending or receiving data,otherwise all scanned data or transmission data will be deleted.The machine automatically enters the Energy Save mode 15 min after the lastoperation is performed.The time until the machine enters Energy Save mode can be specified from theUtility mode. For details, refer to “Specifying the Setting for “ENERGY SAVEMODE”” on page 7-6 in the chapter “Using the Utility Mode”.When the Machine is Turned OnWhen the machine is turned on, the [Start] key indicator lights up in orange toindicate that the machine is ready to begin printing.At this time, the machine can be set for the Auto Print Start function by loading adocument into the Auto Document Feeder, and pressing the [Start] key.Pressing the [Start] key at this time will not immediately start the print cycle. You willhave to wait for less than 25 seconds (at an ambient temperature of 73.4°F / 23°C).
