Lenovo ThinkSystem SR665 V3 User Manual

Also see for 7D9A: System configuration guide User guide

• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configurationinformation.Watch the procedureA video of this procedure is available at YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-DR4X1YAcp9wFKhwj_tLQ5Y.ProcedureStep 1. Make preparation for the task.a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to thetop cover, or remove the server from the rack. See “Remove the server from rack” on page 49.b. Remove the top cover. See “Remove the top cover” on page 161.c. Disconnect the cable of the RAID flash power module.Step 2. Remove the RAID flash power module from the air baffle.Figure 88. Removing the RAID flash power module from the air bafflea. Open the retention clip on the holder of the RAID flash power module.b. Take the RAID flash power module out of the holder.After you finishIf you are instructed to return the component or optional device, follow all packaging instructions, and useany packaging materials for shipping that are supplied to you.Install a RAID flash power module on the air baffleFollow instructions in this section to install a RAID flash power module (also called supercap) on the air baffle.About this taskAttention:128 ThinkSystem SR665 V3 User Guide