c. Remove the protective cover that protects the gold contacts on the bottom of the newmicroprocessor. Do not touch the pins on the microprocessor socket or the gold contacts on thebottom of the new microprocessor.Figure 198. Do not touch the pinsd. Note the orientation of the new microprocessor. Hold the new microprocessor by its edges and theninsert one end of the microprocessor into the retainer 1 . Then, pivot the opposite side of the retaineras shown 2 and lower the new microprocessor straight down into the microprocessor socket 3 .Note: The small triangle on one corner of the new microprocessor is the microprocessor orientationindicator. The new microprocessor is in the correct orientation when this indicator faces the trianglein the microprocessor retainer.Figure 199. Installing the microprocessor into the microprocessor retainer210 P720 Hardware Maintenance Manual
