5. Slide the bracket with the new storage drive into the storage drive bay.Figure 64. Installing the type 1 storage drive bracket6. Connect the signal cable and the power cable to the new storage drive, and then close the handles onboth sides of the bracket.To remove or install a 3.5-inch storage drive in a type 2 bracket, do the following:1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 103.2. Locate the storage drive bay. See “Internal storage drives” on page 40.3. Press the pit on the bracket cover, and then grasp the tilted cover to pull the bracket out of the storagedrive bay.Figure 65. Removing the type 2 storage drive bracketChapter 9. Hardware removal and installation 131
