4. Press both clips simultaneously toward each other and pull the conversion bracket out of the rear of thekit.Figure 46. Removing the conversion bracket from the kit5. To remove the 2.5-inch storage drive, flex both sides of the conversion bracket and then remove thedrive out of the bracket. Do not touch the circuit board on the drive.Figure 47. Removing the 2.5-inch storage drive from the bracket6. To install a 2.5-inch storage drive, ensure that the conversion bracket is folded. To fold the bracket, dothe following:a. Remove pins 1 and reinstall them into slots 2 .Figure 48. Removing pins and reinstalling them into new slots122 P720 Hardware Maintenance Manual
