4. To remove the 3.5-inch storage drive, flex both sides of the bracket to remove the 3.5-inch storage drivefrom the bracket.Figure 17. Removing the 3.5-inch storage drive from the bracket5. To install a new 3.5-inch storage drive, flex both sides of the bracket and align pins 1 on the bracketwith the corresponding holes in the new drive.Notes:• Ensure that the circuit board faces downward and the connectors face toward the rear of the bracket.• Do not touch the circuit board on the storage drive during operation.Figure 18. Installing the 3.5-inch storage drive into the bracketChapter 7. Hardware removal and installation 69
