b. Flex both sides of the bracket and align pins 1 on the bracket with the corresponding holes in thenew storage drive.Note: If you are installing a 2.5-inch hard disk drive, ensure that the circuit board faces downwardand the connectors 2 face toward the front of the bracket.Figure 71. Installing the storage drive into the type 1 bracket5. Slide the bracket with the new storage drive into the storage drive bay.Note: Ensure that the storage drive is on the upper side. Flip over the storage drive bracket if necessary.Figure 72. Installing the type 1 storage drive bracket6. Connect the signal cable and the power cable to the new storage drive, and then close the handles onboth sides of the bracket.Chapter 7. Hardware removal and installation 95
