8. If the installed Wi-Fi card supports the Bluetooth function, connect a Bluetooth cable to the Wi-Fiadapter.Note: The Bluetooth cable connects the Bluetooth connector on the Wi-Fi adapter to the 15-in-1 cardreader connector on the system board. See “Parts on the system board” on page 7.9. Attach the Wi-Fi antenna cable connectors 1 to the corresponding Wi-Fi antenna connectors 2 asshown.Figure 154. Installing the Wi-Fi antenna10. Tighten the Wi-Fi antenna cable connectors to secure them to the rear of the computer.What to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the installation or replacement, go to “Completing the parts replacement” on page 145.Completing the parts replacementCAUTION:After replacing a CRU, reinstall all protective covers, including the computer cover, before connectingpower and operating the computer. This action is important to help prevent unexpected electricalshock and help ensure the containment of an unexpected fire that could happen under extremely rareconditions.After completing the installation or replacement for all parts, reinstall the computer cover and reconnectcables. Depending on the parts you installed or replaced, you might need to confirm the updated informationin the Setup Utility program. Refer to “Using the Setup Utility program” on page 37.Chapter 7. Hardware removal and installation 145
