b. Flex both sides of the bracket to remove the converter from the bracket.Figure 79. Removing the converter from the type 1 bracketc. Lift the tab 1 of the metal bracket and push the metal bracket with force as shown. Then slide thebracket and remove it from the plastic frame.Figure 80. Removing the metal bracket from the plastic frame of the converterd. Carefully flex both sides of the metal bracket to remove the storage drive from the bracket.Figure 81. Removing the storage drive from the metal bracket of the converter4. To install a 2.5-inch storage drive with a converter in a type 1 bracket, do the following:a. Open the handles on both sides of the storage drive bracket and pull out the empty bracket.b. If the converter is installed in the bracket, flex both sides of the bracket to remove the converter fromthe bracket.Chapter 7. Hardware removal and installation 99
