b. Press the tabs 1 toward each other as shown, and slide the new optical drive halfway into the bayfrom the front of the computer. Then, release the tabs and continue to slide the optical drive into thebay until it snaps into position.Figure 13. Installing the optical drivec. Connect the signal cable and the power cable to the new optical drive.Note: Reconnect any cables removed from other supported devices.Figure 14. Connecting cables to the optical driveWhat to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the installation or replacement, go to “Completing the parts replacement” on page 145.Storage drive in the front-access storage enclosureAttention: Do not open your computer or attempt any repair before reading and understanding the “Readthis first: Important safety information” on page v.Chapter 7. Hardware removal and installation 67
