• If the non-hot-swap hard disk drive is secured in the bracket by screws, remove the four screws andthen remove the hard disk drive from the bracket.Figure37. Removing the screws that secure the hard disk drive• If the non-hot-swap hard disk drive is secured in the bracket by retainers, remove the retainers onboth sides and then remove the hard disk drive from the bracket.Figure38. Removing the retainers that secure the hard disk drive5. If you are instructed to return the removed non-hot-swap hard disk drive to the manufacturer, follow allpackaging instructions and use any packaging materials that are supplied to you for shipping.What to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the removal procedure, go to “Completing the parts replacement” on page 90.Installing a non-hot-swap hard disk driveAttention:Do not open your server or attempt any repair before reading and understanding the Safety Information and theWarranty and Support Information on the ThinkServer Documentation DVD that came with your product, and“Guidelines” on page 21. To obtain a copy of the publications, go to:http://www.lenovo.com/supportThis section provides instructions on how to install a non-hot-swap hard disk drive. This section appliesonly to server models that support non-hot-swap hard disk drives.Chapter 5. Installing, removing, or replacing hardware 49
