Table 15. Submenus under the Memory RAS and Performance ConfigurationItem Option DescriptionSelect Memory RAS Configuration Select the RAS configuration forinstalled memory modules.NUMA Optimized Disabled / [Enabled] Whether the BIOS contains the ACPIconfiguration form required by NUMAOS.Note: The settings in [ ] are the default settings in the Setup Utility program.Table 16. Submenus under the Mass Storage Controller ConfigurationItem Option DescriptionOnboard SATA Controller Disabled / [Enabled] Enable or disable the integrated SATAcontroller.SATA Mode [Enhanced] / Compatibility / AHCI /SW RAIDTo select the SATA mode.Note: The settings in [ ] are the default settings in the Setup Utility program.Table 17. Submenus under the Serial Port ConfigurationItem Option DescriptionSerial A Enable Disabled / [Enabled] Enable or disable the serial port 1 I/O.Address [3F8] / 2F8 / 3E8 / 2E8 Select the serial port 1 I/O address.IRQ 3 / [4] Selecttheserialport1I/Ointerruption.Serial B Enable Disabled / [Enabled] Enable or disable the serial port 2 I/O.Address 3F8 / [2F8] / 3E8 / 2E8 Select the serial port 2 I/O address.IRQ [3] / 4 Selecttheserialport2I/Ointerruption.Note: The settings in [ ] are the default settings in the Setup Utility program.Table 18. Submenus under the USB ConfigurationItem Option DescriptionUSB Controller [Enabled] / Disabled Enable or disable the USB function.Legacy USB Support Disabled / [Enabled] / Auto Enable or disable the support onlegacy USB devices.Port 60/64 Emulation [Enabled] / Disabled Enable or disable the I/O port. Thisfunction is for the operating systemthat does not support on legacy USBdevices.Make USB Devices Non-Bootable [Disabled] / Enabled Set the USB device as non-bootabledevice.Device Reset Timeout 10 sec / [20 sec] / 30 sec / 40 sec Set the device reset timeout.USB 2.0 Controller [Enabled] / Disabled Enable or disable the USB 2.0support.Note: The settings in [ ] are the default settings in the Setup Utility program.Chapter 6. Configuring the server 99
