250 Keysight E1406A User Manual and SCPI Programing GuideKeysight E1406A Command Reference VXI Subsystem– If the command module is the resource manager, it can reset any devicewithin the mainframe. If the command module is not the resourcemanager, it can only reset devices within its servant area. You cannot useVXI:RESet to reset the command module (use DIAG:BOOT).– When a device is reset, the command module (system instrument) willwrite 1’s to the device dependent bits in the device’s Control Register.– This command has been retained for compatibility with existing programs.For new programs you should use VXI:RESet?.ExampleReset a VXIbus DeviceVXI:RES 64 Reset device at logical addr 64.:RESet?VXI:RESet? resets the selected logical address. SYSFAIL generation is inhibitedwhile the device is in the self-test state. The command waits for 5 seconds oruntil the selected device has indicated passed (whichever occurs first). If thedevice passes its self-test, the SYSFAIL generation is re-enabled. If the devicefails the self-test, then SYSFAIL generation will remain inhibited.Comments– The return value from this command is the state of the selected deviceafter it has been reset. The command returns a encoded as follows:0 = FAIL, 2 = PASS, 3 = READY– The state of the A24/A32 enable bit is not altered by this command.– If the command module is the resource manager, it can reset any devicewithin the mainframe. If the command module is not the resourcemanager, it can only reset devices within its servant area. You cannot useVXI:RESet? to reset the command module (use DIAG:BOOT).– Related Commands: VXI:SELect:ROUTe:ECLTrgVXI:ROUTe:ECLTrg configures the routing of the ECL trigger line specified by for all mainframe extenders in the system.ParametersParameterNameParameterTypeRange of Values DefaultUnits numeric 0 or 1 none
