|
Keysight E1406A User Manual and SCPI Programing Guide 233VXI Subsystem Keysight E1406A Command Reference– Tables must start on an even address. Note that DIAG:NRAM:CREateallocates RAM for the table with an even starting address.– may be specified in decimal, hex (#H), octal (#Q), or binary (#B)formats.– Setting address to 0 (zero) prevents the parameters defined by the tablefrom being invoked when the system is rebooted, however, the tableremains in user RAM.– For more information see the “ User-Defined Logical Address and MemoryWindows”.– Related Commands: DIAG:NRAM:CREate, DIAG:NRAM:ADDRess?,DIAG:DOWNload, VXI:CONF:ETABle?ExampleLink an Extender Table to the ProcessorDIAG:NRAM:CRE Allocate space for table in user RAM.DIAG:BOOT Reboot system to complete allocation.DIAG:NRAM:ADDR? Get starting address of table (RAM segment).DIAG:DOWN , Download data into table.VXI:CONF:ETAB Link table to processor.DIAG:BOOT Reboot system to implement table.:CONFigure:ETABle?VXI:CONFigure:ETABle? returns the starting address of the user’s extender table.ExampleQuery Address of the Extender TableVXI:CONF:ETABle? Ask for address.enter statement Return address.:CONFigure:HIERarchy?VXI:CONFigure:HIERarchy? returns current hierarchy configuration informationabout the selected logical address. The individual fields of the response arecomma separated. If the information about the selected logical address is notavailable from the destination device (that is, the requested device is not in themainframe or the command module’s servant area) then Error -224, "Illegalparameter value" will be set and no response data will be sent.
|
