6-30 Keysight B2961A/B2962A User’s Guide, Edition 3Function DetailsTrigger SystemTrigger OutputB2961A/B2962A can output trigger at the timing of Trigger output shown in Figure6-7. The trigger output terminal can be selected from the following terminals.• Internal bus, INT1, INT2• LAN port• Digital I/O pin, EXT1, EXT2, EXT3, EXT4, EXT5, EXT6, EXT7, EXT8,EXT9, EXT10, EXT11, EXT12, EXT13, EXT14The trigger output can be set by using “Trigger Configuration dialog box” on page4-36. The trigger output timing and the setup parameters are shown in Table 6-5.Table 6-5 Trigger Output Timing and Setup ParametersFor using a digital I/O pin, it is necessary to set function of the pin, output triggerpolarity, type, pulse width, and the Output Trigger Timing parameter. See “DIOConfiguration dialog box” on page 4-45 and “Using Digital I/O” on page 3-37.NOTE In addition, the trigger outputs are also available for Phase marker of sinusoidalwave and Trigger points of user defined wave by using the terminals which are notassigned to the above trigger outputs. For setting these trigger outputs, see“Function Parameters” on page 4-13.Trigger output timing Layer Action TriggerOutputOutputTriggerTimingStarting ARM loop ARM TRANS. fortransientaction orACQ. foracquireactionON BEFOREEnding ARM loop ARM ON AFTERStarting TRIGGER loop TRIGGER ON BEFOREEnding TRIGGER loop TRIGGER ON AFTERStarting Transient device action ACTION TRANS. ON BEFOREEnding Transient device action ACTION TRANS. ON AFTERStarting Acquire device action ACTION ACQ. ON BEFOREEnding Acquire device action ACTION ACQ. ON AFTER
