4-28 Keysight B2961A/B2962A User’s Guide, Edition 3Front Panel ReferenceConfig key groupGroup Only on 2-channel models. Channel grouping ON or OFF.If this function is ON, the channels perform synchronouschannel operation. The present setting is indicated by anasterisk on the softkey label.Save, Recall Saves/recalls all setup information of the B2961A/B2962A. Five storage areas areavailable in the built-in non-volatile memory (NVRAM) for this purpose.Press the Save or Recall softkey to display the softkeys #1, #2, #3, #4, and #5 usedfor selecting the storage area. Press a softkey to save or recall the setup information.Output Connection dialog boxThis dialog box provides the following parameters for setting the channel operationand connection.Ch Only on 2-channel models. Channel 1 (Ch 1) or2 (Ch 2)This field specifies the channel set by thisdialog box.Sensing Type Sensing type, 2-wire connection (2-WIRE) or4-wire connection (4-WIRE). Set 4-WIRE forremote sensing.Low Terminal State Low sense terminal connection,grounded (GROUND) or floating (FLOAT)High Capacitance Mode High capacitance mode, ON or OFFSet the mode to ON to perform high capacitiveload measurements. See “High CapacitanceMode” on page 6-17.Over Voltage/Current Protection Over voltage or current protection, ON or OFFSet the function ON to turn off the channeloutput automatically and immediately when itreaches its limit.Output-Off State Output-off state, high impedance (HIGH Z),normal (NORMAL), or zero volt (ZERO)This is the source setup condition after outputoff. See Table 6-1 on page 6-15.Auto Output-On Automatic output on function, ON or OFF
