Keysight B2961A/B2962A User’s Guide, Edition 3 4-31Front Panel ReferenceConfig key groupTable 4-4 Ranging Mode used for Sweep Source OperationOutput R (Emulation) dialog boxThis dialog box provides the following parameters to set up the emulation table forprogrammable output resistance setting.Ch Only on 2-channel models. Channel 1 (Ch 1) or 2 (Ch 2)This field specifies the channel set by this dialog box.# List index.Voltage (V) Voltage value.Current (A) Current value.Mode Source mode: VOLTS or AMPS.Wait Control dialog boxThis dialog box provides the following parameters for setting the source andmeasurement wait time.The source wait time is defined as the time the source channel cannot change theoutput after the start of a DC output or the trailing edge of a pulse.The measurement wait time is defined as the time the measurement channel cannotstart measurement after the start of a DC output or the trailing edge of a pulse.DescriptionBEST In the linear sweep mode, the sweep source channel automatically usesthe minimum range which covers the whole sweep output.In the log sweep mode, the sweep source channel automatically usesthe range which provides the best resolution for each sweep stepoutput.AUTO The sweep source channel automatically changes and sets the rangewhich provides the best resolution to apply the source output for eachsweep step.FIXED The sweep source channel sets the range specified by the rangeparameter Source Ranging: FIXED. See “Optional Parameters” onpage 4-18.
