Kenmore 790.75922 Use & Care Manual

Contents

Kenmore 790.75922 Use & Care Manual Manual pdf 28 page image

General Care & CleaningPullup with finprLeft GlidePushdownwith flnprFigure IFigure 2Removing and Replacing Warmer (Warm & Ready TM) DrawerTo Remove Warmer Drawer:1. _ Turn power off before removing the warmer drawer.2. Open the drawer to the fully opened position.3. Locate glide lever on each side of drawer, pull up on the left glide lever andpush down on the right glide lever (see figure 1).5. Pull the drawer away from the range.To Replace Warmer (Warm & Ready TM ) Drawer:1. Pull the bearing glides to the front of the chassis glide (see figure 2).2. Align the glide on each side of the drawer with the glide slots on the range.3. Push the drawer into the range until levers "click" (approximately 2"). Pullthe drawer open again to seat bearing glides into position. If you do nothear the levers "click" or the bearing glides do not feel seated removethe drawer and repeat steps I thru 3. This will minimize possible damageto the bearing glides."_1_ _ Electrical Shock Hazard can occur and resultin serious injury or death. Disconnect appliance from electricpower before cleaning and servicing the warmer drawer.OvenLightHolderChanging the Oven LightThe oven light automatically turns on when the door is opened. The oven light islocated at the rear of the oven and is covered with a glass shield held by a wireholder. The glass shield must be in place whenever the oven is in use.To replace the oven light:1. Turn electrical power off at the main source or unplug the range.2. Press wire holder to one side to release the glass shield.3. Replace bulb with a new 40 watt appliance bulb.4. Replace glass shield over bulb and snap wire holder into place.5. Turn power back on again at the main source (or plug the range back in).6. The clock will then need to be reset. To reset, see Setting the Clock andKitchen Timer in this Use & Care Guide.¥ Be sure the range is unplugged and all parts are COOL beforereplacing oven light. Wear a leather-faced glove for protection against possiblebroken glass.Care and Cleaning of Stainless Steel (some models)Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining theappearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.28