Kenmore 790.75922 Use & Care Manual

Contents

Kenmore 790.75922 Use & Care Manual Manual pdf 11 page image

Setting the ClockFEATURE OVERVIEWSetting the ClockChanging between 12 0r24hour display"lim_ Cook Sto=_Set_ "timSetting the ClockThe CLOCK @ pad is used to set the clock. The clock may beset for 12 or 24 hour time of day operation. The clock has beenpreset at the factory for the 12 hour operation. When the range isfirst plugged in, or when the power supply to the range has beeninterrupted, the timer in the display will flash with "PF" (powerfailure, See Fig. 1).INSTRUCTIONSTo set the clock (example below for 1:30):1. Press @. "CLO" will appear in the display (Fig. 2).2. Press @ @ @ pads to set the time of day to 1:30 (Fig.3). "CLO" will appear in the display. Press (:_. "CLO"will disappear and the clock will start (Fig. 4).PRESS®®®@@Changing between 12 or 24 hour time of day display:1. Press and hold @ for 6 seconds (Fig. 3). While holding thepad down the current time of day wilt remain and "CLO" willdisappear from the display (Fig. 4). CONTINUE holding thepad until a beep is heard.for 6 seconds2. The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).3. Press @ to switch between the 12 and 24 hour time of daydisplay. The display wilt show either "12:00" (Fig. 5) or"24:00" (Fig. 6).4. Press (_) to accept the change or press @ to reject thechange.@or@5. Reset the correct time as described in To set the Clock above.Please note that if the 24 hour time of day mode was chosen,the clock will now display time from 0:00 through 23:59 hours.0Figure 1DISPLAYFigure 2Figure 3Figure 4Figure 5Figure 611