Kenmore 790.75922 Use & Care Manual

Contents

Kenmore 790.75922 Use & Care Manual Manual pdf 25 page image

Oven CleaningFEATURE OVERVIEWDelayed Self-Clean Cycle (Cont'd)INSTRUCTIONSStopping or Interrupting a Self-Cleaning Cycle:If it becomes necessary to stop or interrupt a self-cleaning cycledue to excessive smoke or fire in the oven:1. Press _.2. Once the oven has cooled down for approximately 1 HOUR andthe "DOOR LOCKED" icon is no longer displayed, the ovendoor can then be opened (Fig. 2-1).PRESS®DISPLAYAdjusting Oven TemperatureFEATURE OVERVIEWThe temperature in the oven has been pre-set at the factory. When first using the oven, besure to follow recipe times and temperatures. If you think the oven is too hot or too cool, thetemperature in the oven can be adjusted. Before adjusting, test a recipe by using atemperature setting that is higher or lower than the recommended temperature. The bakingresults should help you to decide how much of an adjustment is needed.INSTRUCTIONS PRESSTo adjust the oven temperature higher:1. Press (_ for 6 seconds (Fig. 1). (_2. To increase the temperature use the number pads to enter thedesired change. (Example 30°F) _ @ (Fig. 2). The _ @temperature may be increased as much as 35°F (17°C).3. Press _) to accept the temperature change and the (_display will return to the time of day (Fig. 3). Press _ toreject the change if necessary.To adjust the oven temperature lower:Press (_ for 6 seconds (Fig. 4).1.2. To decrease the temperature use the number pads to enter thedesired change. (Example-30°F)_@ and then press _(_)(_) (Fig. 5). The temperature may be decreased as muchas 35°F (17°C).3. Press _) to accept the temperature change and the (_display will return to the time of day (Fig. 6). Press _ to _)reject the change if necessary.Figure 2-1Note: The oventemperature adjustmentsmade with this feature wiltnot change the Self-Cleancycle temperature.DISPLAYFigure 1Figure 2Figure 3Figure 4Figure 5Figure 625