Kathrein UFD 520 Operating Manual

Also see for UFD 520: Mode d'emploi Mode d'emploi

Contents

Kathrein UFD 520 Operating Manual Manual pdf 50 page image

Data transfer from receiver to receiverData transfer from receiver to receiverYour receiver is able to accept data from another receiver via the RS232C socket.For this purpose, the two receivers are mutually connected via a zero modem ca-ble. The transmitting receiver is the master, the receiving receiver the slave.PreparationThe master and slave are first switched to standby mode and then disconnectedfrom the mains by pressing the power switch.The data sockets (Item 6, rear of receiver, Page 8) of both receivers are connectedwith the zero modem cable.The master is then switched on again.Transferring programme listsSimultaneously press the button (arrow left) and SELECT under the front panelof the master to transfer the programme list.The slave can now be switched on. The transfer procedure begins.While loading, the display of the master shows "t001 t002 .. t00n“ while the slavecorrespondingly shows "r001 r002..r00n“.The LED display shows "----" during block transfer.The loading procedure was successful if both receivers show the message "Succ."Transferring operating softwareFollow the same procedure as described above for the purpose of transferring op-erating software.Start transfer of the operating software by simultaneously pressing the button(arrow right) and SELECT under the front panel of the master.While loading, the display of the master shows "t001 t002 .. t00n“ while the slavecorrespondingly shows "r001 r002..r00n“.The LED display shows "----" during block transfer.The loading procedure was successful if both receivers show the message "Succ.".Should transfer problems occur, "F * * *" will appear in the master display where *stands for a numerical value. In this case, check the cable connection and start anew transfer attempt.The data transfer from receiver to receiver as described above must only be car-ried out with devices of the same type as otherwise malfunctions or total loss of theoperating software may occur.On no account must the receivers be switched off or the connection interruptedduring data transfer. This may otherwise result in data loss, malfunctions or totalfailure of the operating system.In all cases wait until the "Succ." or "F * * *“ message appears on the display.You can download new operating software as well as a new programme list at ourwebsite www.kathrein.de where you will also find the corresponding instructions.Refer to the section "System information" to establish the status of your receiver.50