Kathrein UFD 520 Operating Manual

Also see for UFD 520: Mode d'emploi Mode d'emploi

Contents

Kathrein UFD 520 Operating Manual Manual pdf 21 page image

Programme selectionReception status - radioAfter the switch-over of the receiver, simply press the buttons to selectother radio programmes in their ascending or descending order in the programmememory.Every time you press the button, an on-screen display shows you the selectedprogramme together with the time, theprogramme start and end times as well asthe programme title in the information boxprovided these data are transmittedtogether with the signal.By pressing the button, you can exit this information box permanently displayedor switch it off by pressing the button once again.A further option of selecting a differentprogramme is to press the button.The radio programme list is nowdisplayed. In the left column, it willprovide information relating to thereceived satellites, the transponder andits transmission frequency, thepolarisation, the symbol rate and thescrambling. The programme number, theprogramme broadcaster and the type ofreception signal (free to-air/scrambled) isshown on the right.By pressing the buttons you jump to the next programme and by press-ing the buttons you jump to the neighbouring page or enter-in the channelnumber with the buttons on the remote control.Confirm your programme selection by pressing the button, or press thebutton to exit the programme list and remain in the programme already set.Selecting a radio programme by number entryYou can select a different radio programme during a current radio programme byentering the programme location number. Use the number buttons to forthe purpose of entering the programme location number.Example You wish to select the radio programme "DLR-Berlin". This programme is storedunder the programme location number 015. (The order of radio programmes is de-fined in the programme memory and therefore only serves as an example here.)To select this programme, press the numbers and one after the other. Thereceiver waits for about 3 seconds for entry of the next number.Follow the same procedure for all other programmes – i.e. also programmes withthree-digit programme location numbers. You do not have to enter leading zeros.21