Kathrein UFD 520 Operating Manual

Also see for UFD 520: Mode d'emploi Mode d'emploi

Contents

Kathrein UFD 520 Operating Manual Manual pdf 22 page image

Timer settingsTimer settingsYou can use the timer for recording a programme with a video recorder on time.Seven timers are available which you can set to different programmes as well asstart and end times.To access the timer setting, press to enter the main programme menu,to go to system parameters,followed by and to localtime / timer and . The screen shownin the margin appears.Press the buttons to move thecursor to the desired timer and confirm itby pressing . Press to exit thetimer again.Incorrect time settings will be rejected.You can select and set the programme type, TV or radio, the programme location with name (numerical via the remote control), the start time (date, month, year, hour, minute) the stop time and the timer status (inactive/once/daily/weekly)for seven timers. You must enter leading zeros for the time settings.You can also carry out the pre-programming via the EPG (Electronic ProgramGuide). Refer to section „Programme overview – Full EPG."Use the or and the number buttons to make the required setting.The current time that you must re-enter appears under the start time. If no othersetting is entered, the end time will be set automatically to the same date and onehour after the start time.Finally confirm the settings by pressing or 3 times.VPS-SignalMake certain, that no VPS signal is included in the digital television signal.Therefore, you will need to programme your video recorder corresponding to thetimer settings.22