Kathrein UFD 520 Operating Manual

Also see for UFD 520: Mode d'emploi Mode d'emploi

Contents

Kathrein UFD 520 Operating Manual Manual pdf 19 page image

Programme selectionProgramme selectionThis section describes how you select analogue and digital TV programme withyour receiver and how you can set the required volume.This description of the functions assumes that the receiver has been connectedcorrectly.If you wish to connect the receiver yourself, please read the section "Connectionand start-up" beforehand.Selecting a TV programmeReception status digitalThe following information describes how to select other channels and shows whatthe on-screen displays look like.After switching on the receiver, simply press the buttons, in order to se-lect other TV programmes in theirascending or descending order in thechannel memory.Every time you press the button, an on-screen display shows you the selectedprogramme together with the time, theprogramme start and end times as well asthe programme title in the information boxprovided these data are transmittedtogether with the signal.By pressing the button, you can leavethis information box permanently dis-played or switch it off by pressing thebutton once again.You will receive the "channel scrambled" message for scrambled channels.A further option for selecting a different programme is to press the button. TheTV programme list is now displayed. In the left column, it will provide for digitalprogrammes information relating to the received satellites, transponder and itstransmission frequency, polarisation,symbol rate and scrambling. The pro-gramme number, the programmebroadcaster and the type of receptionsignal (analogue/digital) is shown on theright.With the uttons you jump to the next programme,with the buttons you jump to theneighbouring page or with the buttons on the remote control enter the programmenumber (Ch). Confirm your selection by pressing the button. Press thebutton to exit the programme list and remain in the already set programme.19