Kaco blueplanet 15.0 TL3 Operating Instructions Manual

Also see for blueplanet 15.0 TL3: Manual Manual Manual Operating instruction Quick guide

Kaco blueplanet 15.0 TL3 Operating Instructions Manual Manual pdf 15 page image

ENMountingKACO Operating Instructions blueplanet 15.0-20.0 TL3 Page 15Unpack inverter1. Open carton at the front.2. Remove installation material and documentation.3. Slide the unit aside the housing out of the carton.4. Remove the protective packaging from the top and bottom of the unit and place back into the carton.5. Lift the inverter to the intended positions (see Figure 9).» Continue mounting the inverter.6.2 Installing the unit250mm250mm250mm500 mm 500 mm700 mm700 mm65,5mm1234513864052605651120328Figure 10: Minimum distances/wall bracket Figure 11: Position of wall bracket / suspensionKey1 Fixings for mounting 4 Detachment protector2 Wall bracket 5 Suspension brackets (back of housing)3 Screws for mountingInstalling the wall holder and the device1. Mark the positions of the drill holes using the slots in the wall holder. NOTE: The minimum clearances betweentwo inverters, or the inverter and the ceiling/floor have already been taken into account in the diagram.2. Fix wall bracket to the wall with the supplied mounting fixtures. Make sure that the mounting plate is orientedcorrectly.3. Hang the inverter on the wall bracket using the suspension brackets on the back of the housing.4. Fix the inverter with the enclosed screws to the detachment protector at the connection area.» The mounting of the inverter is complete. Continue with the installation.NOTEPower reduction due to heat accumulation.If the recommended minimum clearances are not observed, the inverter can go into power regula-tion mode or protective shutdown due to insufficient ventilation and the resulting heat buildup.› Maintain minimum clearances.› Provide for sufficient heat dissipation.