KLN Series 022014 3-373.6.3.3 CHANGING LAN PASSWORDWhen operating the KLN via the LAN for the first time, click Security at the top left of the Wel-come Page to bring up the Change Password screen (Figure 3-12). If desired, change the oldpassword from the default (admin) to one of your choosing. Ensure that New Password andConfirm Password fields are identical. If the password is lost, it can be reset to “admin” by exe-cuting the IP Address Reset (RST1) from the front panel (see PAR. 3.3.49). however this willalso reset other LAN settings to the default as well.FIGURE 3-12. CHANGE PASSWORD SCREEN3.6.3.4 INSTRUMENT CONTROLThe Instrument Control page (see Figure 3-13) contains the basic controls used to operate theKLN power supply. To view the Instrument Control page, click on Instrument Control at the topleft of the Welcome page. You may be asked to Log In with a password before access to thisscreen is granted. Voltage and current setpoints are displayed above the empty fields above theSet V and Set I buttons, respectively. The output can be enabled by the OUTPUT ON/OFF but-ton at the right. If the output is on, the ON indicator (at the lower left of the group of six indica-tors) is on, and the voltage and current displayed appear at the output. To programvoltage/current, enter the setpoint value in the field above the corresponding SET button, thenclick the SET button to apply the change. The CC, CV, OCP, OVP ON and Alarm indicators cor-respond to the front panel indicators (see Figure 3-1 (750W), 3-2 (1500W), or 3-3 (3000W), andTable 3-1. The RESET button corresponds to the front panel RESET button.FIGURE 3-13. INSTRUMENT CONTROL PAGE
