KEPCO KLN 750W Operator's Manual

Also see for KLN 1500W: Instruction manual

Contents

KEPCO KLN 750W Operator's Manual Manual pdf 13 page image

KLN Series 022014 1-33000W 2U Full Rack ModelsKLN 6-400 0 to 6 0 to 400 23 1000 2.8 42 6.2 85 0.08 0.02 0.5 1KLN 8-360 0 to 8 0 to 360 23 1000 2.8 42 6.2 85 0.08 0.02 0.5 1KLN 12.5-240 0 to 12.5 0 to 240 23 800 3.2 29 7.1 60 0.08 0.1 0.8 1KLN 20-150 0 to 20 0 to 150 23 600 4 18.5 8 38 0.08 0.1 0.8 1KLN 30-100 0 to 30 0 to 100 23 310 5 13 9.5 27 0.08 0.16 0.9 1.5KLN 40-76 0 to 40 0 to 76 23 250 6 10.5 11 22 0.08 0.16 1 2KLN 50-60 0 to 50 0 to 60 23 200 7 9 13 19 0.08 0.16 1.1 2KLN 60-50 0 to 60 0 to 50 23 150 8 7.5 14 16 0.08 0.16 1.1 3KLN 80-38 0 to 80 0 to 38 23 110 10 6.2 17 13.4 0.15 0.3 1.2 4KLN 100-30 0 to 100 0 to 30 23 90 12 5.3 20 11.6 0.15 0.3 1.5 5KLN 150-20 0 to 150 0 to 20 36 90 17 4.2 27.5 9.4 0.15 0.3 2 5KLN 300-10 0 to 300 0 to 10 57 50 32 3.1 50 7.2 0.15 0.3 3.5 5KLN 600-5 0 to 600 0 to 5 170 30 62 2.55 95 6.1 0.25 0.5 4 5NOTES:1. Actual output voltage should be 0.1% of rated voltage when output voltage is set to zero.2. Actual output current should be 0.2% of the rated current when output current is set to zero (resistive load).3. Measured when output is within 10%-100% of rated value; ripple bandwidth: 300kHz (rms), noise bandwidth: <20MHz (p-p).4. For 6V model: measured when output voltage 2-6V and rated current; all other models measured when output 10-100% of rated voltage and ratedcurrent.5. Input voltage 100-240V a-c (190-240V a-c for 3000W models), 50/60Hz, constant load.6. Constant input voltage and output from no load to full load.7. With rated input, resistive load.8. Rated power output with input 115V or 230V a-c9. Specifications met after 30 minutes of operation, ambient temperature 23±5°C, humidity under 80% R. H, nominal a-c input voltage ±5%, THD 2%,not using the remote compensation, not operating in series or parallel.10. For example, the spec for KLN 6-100 line regulation and load regulation in CV mode is 0.05% + 2.8mV (or 6 x 0.0005 = 3mV +2.8mV =5.8mV).11. Add G suffix for models with optional GPIB interface, add E suffix for optional LAN interface.12. Specifications subject to change without notice.TABLE 1-2. KLN GENERAL SPECIFICATIONSSPECIFICATION RATING/DESCRIPTIONINPUT CHARACTERISTICSInput voltage 750W, 1500W:3000W:100~240Vac, 50/60Hz127V~373V d-c (1)190~240Vac, 50/60Hz254V~370V d-c (1)Input current (Full load) 750W:1500W:3000W:115Vac - 8.1A; 230V a-c - 4.1A115Vac - 16.2A; 230V a-c - 8.1A230V a-c - 15.6AInrush current 750W:1500W:3000W:230Vac - 12.5A230Vac - 25A230Vac - 50APower Factor (PF)Typical750W,1500W:3000W:0.99 (at 115V a-c, rated output)0.99 (at 230V a-c, rated output)(1) Connect (+) to L and (–) to N. Safety agency approvals apply to a-c input operation only.TABLE 1-1. KLN SERIES MODEL PARAMETERS (CONTINUED)Model(8)(9)(11)(12)d-c Output Range Ripple (3) Line Regulation (5)(10) Load Regulation (10) Response Time (7) RemoteSenseVoltagedrop(max.)ConstantVoltage(CV) (1)ConstantCurrent(CC) (2) CV CC (4) CV CC CV (6) CC (6) FullLoadUpFullLoadDownNoLoadDownV d-c A d-c mVrmsmArms0.05%+mV0.1%+mA0.05%+mV0.1%+mA Sec Sec Sec V