KLN Series 022014 3-133.3.15 I/O SELECTUsed to select either RS-485 (standard) or optional GPIB or LAN interfaces for remote digitalcontrol.1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage displayshows (I.O) to access I/O SELECT setting.2. Press ENTER key to view setting.RS-485 mode displayed as (485) in Current display.GPIB mode displayed as (GPIB) in Current display if GPIB interface installed.LAN mode displayed as (LAN) in Current display if LAN interface installed.3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.3.3.16 RS-485 BAUD RATEUsed to select baud rate for RS-485 communication. Default setting is 115K1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage displayshows (485) to access RS-485 BAUD RATE setting.2. Press ENTER key to view setting.4800 baud rate displayed as (4.8K) in Current display.9600 baud rate displayed as (9.6K) in Current display.19200 baud rate displayed as (19.2K) in Current display.38400 baud rate displayed as (38.4K) in Current display.57600 baud rate displayed as (57.6K) in Current display.115200 baud rate displayed as (115K) in Current display.3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.3.3.17 GPIB ADDRESS (GPIB INTERFACE ONLY)Used to set the GPIB address. Available addresses from 00 to 30. Default GPIB address is 07.1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage displayshows (GPIB) to access GPIB ADDRESS setting.2. Press ENTER key to view setting.GPIB address (default) displayed as (07) in Current display.3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
