JVC LST0728-001B Instructions Manual

Contents

41Playing, Skipping and Stopping RecordedImagesControl using the [PLAY], [SKIP], and [STOP(PB)] buttons. Control using the [PLAY], [SKIP], and[STOP(PB)] buttons on the front panel Playing Back1 Press the [PLAY] button● Playback starts from the date/time indicated on the[Master Time] of [Time Navigation].● Images are played back according to the angle of theshuttle dial (x1/20, x1/5, x1, x2, x5, x10, x20). Skipping1 Press the [SKIP] button● The [SKIP] buttons have the following functions.Memo :● “Sequence” indicates a certain block of images that are recordedduring motion detection.● Recorded images are stored in the database.Note :● The [SKIP] buttons are only enabled when a camera has beenselected.● During simultaneous recording and playback, an AAfterDatabase EndB message may appear as playback catches upwith recording during playback near the current time.● When recording is set to be triggered by motion/event(A Page 57), recording will not start unless a motion/eventoccurs. During playback near the current time, however, theimage that is not recorded will also be played. Stopping1 Press the [STOP(PB)] button● Playback stops. Enlarging a Display● Entering the number of the selected camera switches to anenlarged display.● To return to normal display, enter the camera number of theenlarged display.Adjusting the Playback Speed (Jog/Shuttle Playback)You can adjust the playback speed by turning the jog dial/shuttledial on the front panel. Shuttle Playback● Rotate the shuttle dial during playback or when playback ispaused to start fast forward, fast reverse or slow playback.Memo :● The playback speed that is indicated during fast forward or fastreverse playback by rotating the shuttle dial is an approximatevalue. The speed may differ depending on the conditions, suchas the playback mode (multi-view, single view) and the recordingmode (motion detection, recorded frame rate). Jog Playback● Rotate the jog dial to play back frame by frame.● Rotate the dial clockwise to play back a single frame in theforward direction, and rotate the dial counterclockwise to playback a single frame in the reverse direction.● Release the dial to pause the playback. However, when framesare played back successively in the forward or reverse direction,playback may continue momentarily after the jog dial is released.Note :● The jog dial is only enabled when a camera has been selected.● When the playback speed is adjusted or when playing back athigh speed during recording, the frame rate of the recording maydecrease. Check the performance meter while adjusting theplayback speed to ensure that the display does not turn red.S Moves to the first image in the previous sequence.Moves to the first image in the database of the selectedcamera when the button is pressed and held down.T Moves to the first image in the next sequence. Press andhold down the button to move to the latest image in thedatabase of the selected camera.NVR Viewer[Master Time] area[Time Navigation] Section[Go To] Button[Browse] ScreenstillREV FWDJog/Shuttle dialShuttle Dial (External)Jog Dial (Internal)