98ApplicationsSpecifying an Output1 Select the camera for specifying the event fromthe [Defined events] list on the [I/O Setup]screen2 Click the [Add new output event...] button● The [Add New Output] screen appears.3 Specify the output connection destination,output holding time, and output nameNote :● The [Add new output event...] button is disabled if there is nooutput available for use by the network camera.[Advanced] ScreenThe [Advanced] screen enables you to specify network settings forhandling events.1 Click the [Advanced...] button on the [I/O Setup]screen● The [Advanced] screen appears.2 Specify the following items.Camera Input/Output Portand Events (continued)Item DescriptionA Externaloutputconnected toDisplays the device name for whichoutput is specified. (This is a read-onlyfield.)B Outputconnected onFor selecting which destination toconnect the output to.C Keep outputforFor specifying the output holding time inunits of 1/10 seconds or seconds.D Externaloutput nameFor specifying a name for the output.Memo :● The following characters cannot beused as part of the event name.< > & ^8217 ^8220 \ / : * ? | [ ]E Test Output Click this to perform a test on the outputsettings.21ADBCE[Add new output] ScreenItem DescriptionA Ftp ServerPortFor specifying the port number to use forsending event information from the device tothe surveillance system via FTP. (Specify anumber between 1 to 65535.)B Alert Port For specifying the port number to use forhandling warnings related to events, includinggeneric events. (Specify a number between 1to 65535.)C SMTPPortFor specifying the port number to use forsending event information from the device tothe surveillance system via SMTP. (Specify anumber between 1 to 65535.)[I/O Setup] ScreenClickABCD[Advanced] Screen
