Honeywell VISTA-128BPT Installation And Setup Manual

Also see for VISTA-128BPT: User guide Overview Programming guide User guide Installation and setup guide

Contents

Honeywell VISTA-128BPT Installation And Setup Manual Manual pdf 74 page image

VISTA-128BPT/VISTA-250BPT Installation and Setup Guide6-6Time WindowNumberStart Time(HH:MM)Stop Time(HH:MM)123…..20A time window must have a start and a stop time.Time Windows ProgrammingEnter Scheduling Mode by entering Installer Code + [#] + [80]. The keypad displays the Time Window Programmingprompt.PROMPT EXPLANATIONTime Window ?1 = YES 0 = NO 0Enter 1 at this main menu prompt to program time windows.Time Window # ?01-20, 00 = Quit 01Enter the 2-digit time window number (01-20) to be programmed.Press [∗] to accept the entry. Enter 00 + [∗] at the “Time Window #?” prompt to quit time windowprogramming and display the “Quit ?” prompt.01 TIME WINDOW00:00AM 00:00AMIf you entered a time window number, the cursor is now positioned on the tens of hours digit of the start ofwindow entry.Enter the desired start of window hour and press [∗]. The cursor moves to the minutes position. Enter thedesired minutes and press [∗]. Toggle the AM/PM indication by pressing any key 0-9 while the cursor isunder the A/P position and then press [∗]. Repeat this to program the stop of window entry.When the entry is completed, the “Time Window #?” prompt is displayed again.Enter the next time window number to be programmed and repeat the procedure.Quit ?1 = YES 0 = NO 0Enter 0 at the Quit ? prompt to return to the main menu choices and continue programming.Enter 1 to quit Scheduling Menu Mode.Because the time windows are shared among all partitions, it is important to make sure that changing atime window does not adversely affect desired actions in other partitions.Daily Open/Close SchedulesEach partition can be assigned one daily open/close schedule, plus a holiday schedule. Temporary schedules areprogrammed separately, using the #81 Temporary Schedule Menu Mode. To program additional open/close schedules,see Time-Driven Events Programming later in this section for the procedure.Open/Close Schedule WorksheetThe following worksheet is an example of the worksheet found in the Programming Guide. Write the previously definedtime window numbers for open and close for each partition.Part Mon Tues Wed Thur Fri Sat Sun HolOp Cl Op Cl Op Cl Op Cl Op Cl Op Cl Op Cl Op Cl123…8