Honeywell Lynx Touch 5100 Frequently Asked Questions Manual

Also see for LYNX Touch 5100: Programming guide

Contents

Honeywell Lynx Touch 5100 Frequently Asked Questions Manual Manual pdf 7 page image

Return to Table of Contents - 7 - Updated: 11/22/13FAQ’sIf Pots is the only desired CS reporting?• Yes, but they need to install a L5100-Wifi card or iLP5, program it in the “Communicator” screen, Do notenter any CS ID, City ID, or acct id information. In Reporter, ensure Communicator type is set to “None”.But this time enter the phone information.• Note – these two options above will work with or without Broadband being available!Wifi/iP only reporting?• Yes, they need to install a L5100-Wifi card or iLP5, program it in the “Communicator” screen, enter CS ID,City ID, or acct id information. In Reporter, ensure Communicator type is set to Wifi or IP as appropriate.• Note – Tablet stops working if either the Internet is down, or if Alarmnet is down (if the ping sent every 20seconds is not acknowledged, the L5100 reboots the wifi card)IP primary with GSM back up?• No, you cannot put IP and GSM in the same unitWifi primary, GSM back up?• Yes, but they need to install a L5100-Wifi card and GSM, program it in the “Communicator” screen, enter CSID, City ID, or ACCT ID information. In Reporter, ensure Communicator type is set to Wifi/GSM.• Note: The tablet will stop working if AlarmNet is not accessible via the L5100-WiFi. When registered withAlarmNet, L5100-WiFi will ping the AlarmNet server every 20 seconds. If the ping is unable to reach theserver, the L5100 will reboot the WiFi card. This will prevent the tablet from working during that time.The tablet does not have Panic keys, how do I send Panic?• Work around is:• Use a 5802wxt panic• Enter a Duress code for burgIs the tablet Supervised?• Yes. The L5100 supervises the Tablet every 15 secondsCan the tablet work with the ILP5 IP communicator?• Yes, it works with either ILP5 or L5100-WiFi, as long as you have a wireless router.