Honeywell Lynx Touch 5100 Frequently Asked Questions Manual

Also see for LYNX Touch 5100: Programming guide

Contents

Honeywell Lynx Touch 5100 Frequently Asked Questions Manual Manual pdf 10 page image

Return to Table of Contents - 10 - Updated: 11/22/13FAQ’sCommunications and Remote Services4G support• L5100 will support the GSMVLP54G 2G/3G/4G radio• L5100 will not support the GSMVLP5 2G only radio• L5000 currently supports only the GSMVLP5 2G radioAPL (Advanced Protection Logic)• APL Is supported by the L5100Are External antennas available for the L5100?• The GSM-EXT is currently available for adding an external antennas to the GSMVLP5-4G.Push Content – how often does content get sent• Wi-Fi/ILP5 – every 4 hours plus on touching the icon• GSM – twice a day, as programmed in TOTAL CONNECT 2.0Slide Show• Slideshow is only available through Total Connect 2.0• No slide show through GSM, only over Wi-Fi/iP• Slide show images are stored in RAM. If the panel recycles power, then all images will need to bedownloaded again. This automatically happens.I no longer see my “Dashboard Icon” on the L5100• If the panel, no longer sees the WiFi/ILP5 card, or GSM card, the “Dashboard Icon” will not show up.Why are my automation devices not showing up in Total Connect 2.0?• The panel data must be synchronized in order for Total Connect 2.0 to recognize the devices.Why does “No Translation Found” appear in the Automation Module?• This happens when Total Connect 2.0 is polling the panel for status on the enrolled Z-Wave devices.

/ 11

Related manuals for Honeywell LYNX Touch 5100