Honeywell LYNX User Manual

Also see for LYNX Touch Security System: Programming guide User guide Quick guide User guide User guide

Contents

Honeywell LYNX User Manual Manual pdf 27 page image

– 27 –SECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESBypassing Protection ZonesBypassing Individual ZonesThe Bypass feature can be used when you want to intentionally arm your system with one ormore zones unprotected. Bypassed zones are unprotected and will not cause an alarm whenviolated while your system is armed. All bypasses are removed when an Off sequenceis performed. Bypasses are also removed if the arming procedure that follows the bypasscommand is not successful. The system will not allow panic, fire or CO zones to bebypassed.Bypassing zonesZonesArm AwayReady To ArmArm StayMoreDelayPhone10:18 AM June 8, 20105000-100-006-V0MessageSystem1. With the system in the disarmed state,select the “Zones” icon. The system displaysthe Zones/Bypass screen.Not Ready To Arm - Fault5000-100-141-V02. FrontDoorSelectFaultFAULTBypass AllFaulted BypassClearBypasses2. Select the zone(s) that you wish to bypassand then select “Bypass” OR if programmed,the “Bypass All Faulted” button allows you tobypass all faulted zones (excluding Panic,Fire or CO zones). The system displays akeypad.Not Ready to Arm - FaultBypass Selected ZonesEnter Code:Cancel5000-100-067-V02 315 6408 97Clear3. Enter a valid Code. The system returns tothe Bypass screen and the zone(s) that arebypassed will be displayed.4. Select the 2 icon to return to the homescreen.5. Arm the system normally. SeeARMINGTHE SYSTEM section for procedure