Honeywell LYNX User Manual

Also see for LYNX Touch Security System: Programming guide User guide Quick guide User guide User guide

Contents

Honeywell LYNX User Manual Manual pdf 18 page image

– 18 –SECURINSECURINSECURINSECURING THE PREMISESG THE PREMISESG THE PREMISESG THE PREMISESArming the SystemArming in Stay ModeUse this mode when you are staying home, but expect someone to use the entrance doorlater. Close all protected perimeter windows and doors before arming. The green READYindicator on the control should be lit if the system is ready to be armed. When armed inSTAY mode, the system will sound an alarm if a protected door or window is opened, but youmay otherwise move freely throughout the premises. Late arrivals can enter through thedesignated entrance door without causing an alarm, but they must disarm the system withinthe entry delay period or an alarm will occur. If Quick Arm was programmed by the installer,you do not need to enter the security code to arm the system. The security code must alwaysbe used to disarm the system, however.The Babysitter Code and Installer Code cannot disarm the system unless it was used to armthe system. In addition, if the system is armed by pressing via Quick-Arming, neither theBabysitter Code nor Installer Code can disarm the system.ZonesArm AwayReady To ArmArm StayMoreDelayPhone10:18 AM June 8, 20105000-100-006-V0MessageSystem1. Select the Arm Stay icon, the system willbeep once and display a keypad.Ready To ArmArm the system in Stay modeEnter Code:Cancel2 315 6408 97Clear5000-100-137-V02. Enter a valid User Code.ORIf Quick Arm has been enabled, select the“Quick Arm” icon.The system will beep three times andannounce“Armed Stay Exit Now”. The exitdelay screen will be displayed. Ifprogrammed the display will count downthe time remaining in the exit delay.Note: If a valid user code is not entered or theConfirm icon has not been selected within10 seconds, the system will return to the“home” screen and it will not be armed.