Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 53 page image

LYNX Touch Installation and Setup Guide- 53 -System OperationUL Audio alarm verification has not been evaluated by UL.Audio Alarm Verification (Two-Way Voice Feature)This feature allows the central station operator to listen, talk to or conduct a two-way conversation with anindividual(s) at the premises. It also assists the operator in gathering information about the nature andlocation of the alarm that may be helpful in responding to police and fire departments. All LYNX Touchcontrol panels are capable of supporting the Two-Way Voice feature. The LYNX Touch does not make systemannouncements when the Two-Way voice feature is active.ActivationFire and CO alarms will prevent the LYNX Touch from starting an AAV session. A new Fire or CO alarm willend an AAV session that is in progress.The LYNX Touch sends the “alarm message” followed by a “Listen-in-to-Follow message” (Contact ID® code606) to the Central Station. The Listen-in-to-Follow message causes the Central Station’s digital receiver totemporarily hold the phone line for approximately 1-minute. When the LYNX Touch receives the “kissoff”from the central station, indicating that the alarm message has been received, the Two-Way Voice (AAV)feature is activated in the (default) “Listen Mode” and sirens and keypad sounds are discontinued. TheLYNX Touch transmits a beep acknowledgment to the Central Station, once per second. The beep alternatesbetween two tones and indicates that the LYNX Touch is waiting for a session command from the CentralStation operator. Once a command is issued the beep acknowledgement is discontinued, however, if acommand is not issued within two minutes the system will “time out” and the call will be terminated.Operator CommandsThe Central Station operator begins the session, which last 5 minutes, by entering one of the valid AAVcommands shown in the table below. The session may be extended 5 minutes, without changing theoperating mode, by pressing the [7] key on the touch-tone phone. Selecting another operating mode alsoresets the session an additional 5 minutes. During the last minute of the 5 minute, session, the LYNXTouch generates two beeps every 30 seconds to alert the Central Station operator that the session is about totime out. The Central Station operator may then extend the session by pressing the [7] key on the touch-tonephone. If the session is not extended the phone line is disconnected, and the session is ended. Sessions maybe ended at any time by pressing the [9] key on the touch-tone phone. The AAV modes are described asfollows:Note: When entering AAV commands make sure the Central Station receiver has been disconnected from the phoneline, otherwise AAV commands may not go through.Key Function1 Talk Mode: Pressing the [1] key on the touch tone phone, enables one-way voice communication from thecentral station to the violated premises, and allows the operator to talk communicate through the LYNXTouch speaker. In this mode the ARMED (red) and READY (green) LEDs blink alternately.2 VOX (Voice) Mode: Pressing the [2] key on the touch-tone phone, enables two-way voice communicationsbetween the central station and the violated premises. In this mode the ARMED (red) and READY (green)LEDs blink alternately.3 Listen Mode: Pressing the [3] key on the touch-tone phone, enables one-way audio from the violated premisesto the central station. The Listen Mode is the start up default mode of the voice feature and allows theoperator to listen through the LYNX Touch microphone. This mode does not affect the existing LED pattern.7 Extends the session 5 minutes without changing its operating mode.9 Ends the session and disconnects the phone line.WWW.DIYALARMFORUM.COM