Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 17 page image

LYNX Touch Installation and Setup Guide- 17 -Mechanics of ProgrammingProgrammingIf the system is Armed or in Alarm, the Tools icon will not be functional. The system must first bedisarmed.To enter Installer Programming Mode:SCREEN ACTIONZonesArm AwayReady To ArmArm StayMoreDelayPhone10:18 AM June 8, 20105000-100-006-V0MessageSystem1. At the Home Screen select “More”.2. Select “Tools”. The system displays a virtual keypad.3. Enter the Installer Code 4112.4. The System Programming Screen is displayed. Select “Program” todisplay the following options:Installer CodeDate TimeZonesKeysSystem TypeCommunicationsComm. DiagnosticsReporterUse the down T arrow to scroll to the next page of options.SounderDefault Config.System Settings5. Selecting an option advances to that Programming screen.Loading Factory DefaultsTo load the factory defaults, enter the Installer Programming Mode and advance to second page of theSystem Programming and refer to following procedure. Refer to the Programming Default Tables section of thismanual to view the Default Tables.If a default table is loaded, any data that has already been programmed into the system will be changedaccording to the default table selected!To Select a Default ConfigurationSCREEN ACTIONSystem Programming...5000-100-035-V0System SettingsSounderDefault Config.1. Select “Default Configuration” to display the following options:Default Config 1Default Config 3Default DownloaderDefault Config 2Default Config 4Note: For a list of the pre-programmed defaults refer to the Default Tablessection.2. Select the desired Default Configuration.3. A Confirmation screen is displayed.4. If “Yes” is selected, the System beeps three times and returns to theDefault option screen.5. If “No” is selected, the System returns to the Default option screen.Exiting Program Mode1. Select the “2” key to exit the current screen. The system returns to the previous screen.2. Select the “2” key as required until system displays a Confirmation screen.3. Select “Yes” to allow the installer to re-enter Programming mode or “No” to prevent re-entry. If “No” isselected, you can still re-enter Program Mode by powering down the unit (remove AC and batterypower) and entering Program Mode within 30 seconds of powering up.4. Select the “2” key again to return to the Home Screen.WWW.DIYALARMFORUM.COM